FORD RANGER AIRBAG NALDEC 24LC04

[PAVLOS2]

HI TO ALL DOES SOMEONE HAVE A CLEAR DUMP FOR THIS AIRBAG UNIT OR CAN CLEAR CRASHED FILE ??

FORD RANGER 2.5 DIESEL 2005 EUROPE MODEL
UNIT:NALDEC UH81 57 K30 D (24LC04)

[melcool]

Try these 2 and see if work!

[PAVLOS2]

I WILL TRY AND LET YOU KNOW IN A WHILE THANKS ALOT !!!

[PAVLOS2]

NO LUCK WITH BOTH FILES :vollkommenauf:LIGHT GOES OUT AND THEN STARTS FLASHING 2 TIMES NON STOP
ANY OTHER IDEAS ????

THANKS FOR HELP ANYWAY

[juozas10]

NO LUCK WITH BOTH FILES :vollkommenauf:LIGHT GOES OUT AND THEN STARTS FLASHING 2 TIMES NON STOP
ANY OTHER IDEAS ????

THANKS FOR HELP ANYWAY

Hi.

Try this... please report... thanks.
Best regards.:wink:

[PAVLOS2]

well friend thanks a lot for your file but still no luck it still has the same responce light goes off and in a while it stars flashing 2 times non stop
I have also tryed other ecu with same numbers just to check if there was any hardware problem but the do exactly the same so its for sure a file problem

[melcool]

Please note this:
If the flash bilnk 2 times. The passenger airbag circuit is defective(circuit open, resistence to low/hi)
If the software was no good the light should flash non stop without pause or should remain ON
If blink ...times:
1 Airbag driver
2 Airbag passenger
3 Airbag ignition circuit/Capacitance for all airbags...etc
4 Belt tensioners
5 Side Airbag driver
6 Side Airbag passenger
7 Impact sensor Side Airbag driver
8 Impact sensor Side Airbag passenger

[adam28]

The Crash data is most likely removed, but you most likely have some DTC's. You need a diagnostic machine that is capable of reading the airbag module.Then you can find out the problem. Maybe you have some resistance in one of the airbag connector plugs, pretty common or maybe one of the crash sensors need replacing.

Cheers

[melcool]

Do you have good airbag for passenger side..... or you have put resistor to emulate(if YES have you put capacitor)?

[PAVLOS2]

I have seen that this code is about pas airbag but the only thing that makes me not to try simulate this airbag is that ford dealer has tryed a good working airbag unit and light goes out with no errors an other thing is that this car doesnt have a obd plug it has the old mazda conector in the engine compartment i tryed with x431 and both ford and mazda software but i never managed to communicate with airbag
I will try to simulate airbag just to see what happens

thanks alot guys !!:ciao:

[PAVLOS2]

here is the news the resistence of pass airbag at unit plug is 2.8 ohm and also i found an other code list for ford that says flsh code 2 is ( control unit fault detected)

does someone have a good working dump for this unit beside the one i posted and be greatfull to upload it ??

[PAVLOS2]

anybody with file please any body ???