PIN CODE REMOVAL ?

[smirnoff_rules]

just done a clone for a m8 and had to setup without the scart changed afew settings and the scarts r working again and flashed with the max blue clone safe f/w , but every time he starts the box it asks for the code ie 1004 is there a way to turn this off as he has the box back now and its working fine just asks for the code ?

cheers

[satsmo]

I know the scart output will not work after first flash in most cases. And as you have said you used the RF output from the VCR socket.

When you done the flash and tuned in it via the TV and RF socket did you do a factory reset and rescan? Another thing to check is if parental control isn't set to on.

[smirnoff_rules]

I know the scart output will not work after first flash in most cases. And as you have said you used the RF output from the VCR socket.

When you done the flash and tuned in it via the TV and RF socket did you do a factory reset and rescan? Another thing to check is if parental control isn't set to on.

didnt do a scan the channels where all there and working ? same as my max thats not a clone

[satsmo]

A factory reset is recommended using the clonesafe fix and so a rescan is necessary after that. This should solve the problem, but I would check parental control also.