Hi guys just got the box done a deep scan, all the channels are there, but when i put it on sky sports 1 it says Scrambled channel.
Any help would be much appreciated guys cheers.
Any help would be much appreciated guys cheers.
-
-
not sure about this box but think you might need to do a factory reset first
sigpic
its the stuff we think we know that stops us all from learning -
as i said i havnt had one of these although i do have a couple of e/vox boxes ,it should be the same .
go to menu
go to config
go to clear data
enter pin
select factory reset
delete all channels will come up press ok then do a power scan.
check this link first m8
sigpic
its the stuff we think we know that stops us all from learningComment
-
Hoopy, Have you flashed the box with the correct firmware before scanning?Sometimes a slow gradual approach does more good than a large gesture.Comment
-
No sorry mate you have to use a null modem cable for that box, Can't be done via usb. Also, If you have a fairly new desktop/laptop you will need a null modem cable to usb adapter as well as a null modem cable. Boxes no longer come pre flashed.Sometimes a slow gradual approach does more good than a large gesture.Comment
-
Yes, unless you know someone who has a really old pc or if you have an old one lying about. Failing that you will have to buy one, You can get them from maplin's but they're about ?20 from there, you should be able to pick one up cheap on flea baySometimes a slow gradual approach does more good than a large gesture.Comment
-
sorry m8 thought you had already flashed box ,
sigpic
its the stuff we think we know that stops us all from learningComment
-
cheers guys will need to get one 2moro.Comment
-
No worries mate, If you have any issues with flashing when you get it have a look round the forums there's loads of help in this topic.Sometimes a slow gradual approach does more good than a large gesture.Comment
-
i have exectly the same problem with nick jnr 2
which my little lad loves , av got all the latest firmware and it still says scrambled channelComment
-
On the nick jnr 2 channel press info twice, take a note of the freqs it will show at the top left hand side.
Now go to Menu, Installation, press OK on User Installation, Enter pin 0000, Highlight the Freqs you noted before by pulling down on your remote then press OK so a tick appears at the side then press manual scan which is the "blue button". Leave it to scan usually takes around 30 seconds then exit back to nick jnr 2 and now the channel should be working..Comment
. quite new to this.
Comment