Problem After Flash EVox Blue

[alanbk]

I have had this issue with a few friends Evox. After I flashed the new firmware "UFL_MAX_BLUE_30_11_08" and loaded a CDF file the box will boot but there is nothing displayed on the screen. They have all been genuine Evox, so this is not a clone issue. Anyone else have this problem and more importantly, how do I sort it ? Thanks in advance....:

[satsmo]

Have you tried them via the VCR coax output, tune it via the TV , factory reset and rescan or load CDF.

Dont use the scart basically until you do this and then it will reset the scart output. Save a CDF before doing below for ease.

1) Connect Eurovox to TV using TV/VCR aerial connection on back of box with a coax lead.
2) Plug Eurovox into mains and switch on.
3) Tune in a spare channel on your TV until you see the Eurovox.
4) You will see a request to enter a PIN – use the master PIN 1004.
5) Enter Menu and go to ‘Config’.
6) Go to ‘Clear Data’.
7) Enter PIN – 1004
8) Go to ‘Factory Default’, click OK.
9) Now scan again or load your CDF.
10) Connect back to scart

[alanbk]

Thanks a lot for the reply. Tried as u said and all was looking good but the PIN screen was illigible on the TV. I reloaded the firmware and now on the LCD of the Evox i have 656F and cannot do anything ??? Any ideas please..

[satsmo]

Try the clonesafe firm Digital Kaos - Downloads - Eurovox Blue Clonesafe UK Fix 011208 and do exactly as above again.

[alanbk]

Have done that and just when I think I am getting somewhere, after putting in 1004 as the PIN, the box freezes and reboots and I am left with a distorted screen. Strange thing is that I do not think that the box is faulty as it was grand before I flashed the file. Thanks a lot anyway....I am at a loss now as to where to go next...

[satsmo]

When you flashed with UFL_MAX_BLUE_30_11_08 did it reboot?

[alanbk]

I want to have your baby's LOL. That file did the trick and I was able to flash the box. Thanks again for the help....Just shows what a great forum this is..