setanta frequency

[n.dockney]

hi, i did 3 deep scans last week, which has helped with pixelating pictures/lost channels etc. does anyone have the frequency code for setanta please. in manchester area. many thanks

[satsmo]

Try 354.000 and let us know if it works or not. Also take a look through the unnamed channels, BICs, etc.

[kpeare]

Teesside area

Hi, in the Teesside area with VM its 363

Keep Smiling

[ruudvandan]

Try 354.000 and let us know if it works or not. Also take a look through the unnamed channels, BICs, etc.

All of my Setanta channels are working on 355, I'm in Manchester too.

[n.dockney]

hi, thanks for the help. have tried both 354 and 355, picture is badly pixelating then it goes off with 'no or bad signal' displayed. have done power scan and deep scan but its still doing it. any suggestions please?
p.s. don't get BICS just tvch3 - 12!

[Fergal]

Try changing the freq to 354750 and save see if that improves it.

[n.dockney]

just tried 354.750 - still as bad but thanks anyway.

[Fergal]

press info twice and check the sig reading check the feed is connected properly also there might be a option in the installation menu to turn the sig boost on if the firmware contains this option.

[rickiggyjordan]

Can anyone help with starview 4 firmware?
Thanks

[gmb45]

Can anyone help with starview 4 firmware?
Thanks

look here m8 -- Digital Kaos - Downloads - Starview

[n.dockney]

signal boost is on. out of all the frequencies i,ve tried, 354.750 gets the best picture but it is still pixelating and volume goes up and down!

[n.dockney]

i know this is a daft question, but does it matter which uhf mode its on? currently on PAL B/G

[satsmo]

PAL I but PAL B/G will not cause any problems. You need to do as Fergal said try in 250 Mhz increments from 344.500 to 355.500, also try with booster off.

[oracle]

Frequency for Setanta Chennales

Hi, I live in Huddersfield area and have exactly the same problem as n.dockney. My Stanta channels were wroking fine on 283.000 MHz but for last couple of weeks it is freezing and skiping every second. I have tried to rescan them but now it has found them on 284.000 but the channels on 284.000 dont work at all.

Does anyone know the working frequency of Setanta channels in West Yorkshire area. Also I want to try 283.250 but not sure how to enter this frequency. when I try to add a new Transponder frequency only takes 5 digits and not sure how to enter point "." in there. I have tried like 28325 but it doesn't get any thing there. Anyone knows how to enter these?

Thanks.