eurovox pvr5100

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • danamite5
    Newbie
    • Mar 2010
    • 14
    #1

    eurovox pvr5100

    hi everyone hope you can help
    basically ive gotta pvr5100 and all the channels are breaking up or freezin they seem to come on for about 5 seconds then just crash the signal and quality are both over 80% when i done deep scan it picked up over 250 channels ive heard about these signal boosters but am not sure thats the problem is it worth flashing again or what, to be honest i dont get it also i seem to get a slightly better signal with the splitter than with the main wire asa say a can pick up evry channel for about 5 seconds includin all the sports before it goes off please help thanks dan!
    Tags: eurovox, pvr5100
    • satsmo
      V.I.P. Member
      • Jun 2008
      • 6397
      #2
      What firmware are you currently using? With the splitter in line you are actually reducing the signal, so an attenuator may help.

      After factory reset and rescan what quality/signal levels are you getting on problem channels?
      I refuse to answer that question on the grounds that I don't know the answer. - Douglas Adams

        Comment

        • danamite5
          Newbie
          • Mar 2010
          • 14
          #3
          Originally posted by satsmo
          What firmware are you currently using? With the splitter in line you are actually reducing the signal, so an attenuator may help.

          After factory reset and rescan what quality/signal levels are you getting on problem channels?
          hi ye the signal is stil over 80% and on quality ive also bought a catv 30db signal booster but to be honest am not sure am usin it properly the firmware is of here but it was done a few wks ago why do you think its worth doin again

            Comment

            • danamite5
              Newbie
              • Mar 2010
              • 14
              #4
              ye it just seems like its sumthin really simple but i avnt gota clue whats wrong with it do you know on the tv settings page can i do anyin there what about this uhf mode an signal booster do they do anythin

                Comment

                • satsmo
                  V.I.P. Member
                  • Jun 2008
                  • 6397
                  #5
                  An attenuator does the opposite of what your booster is doing. I said it may help as when you use a splitter your signal seems to improve. This may be due to the fact that your signal is too strong.

                  The signal booster in TV settings page should be set to off by default. But you may try turning it on and post back the results.

                  Post what it says in system info as you may not have the latest firmware.
                  I refuse to answer that question on the grounds that I don't know the answer. - Douglas Adams

                    Comment

                    • danamite5
                      Newbie
                      • Mar 2010
                      • 14
                      #6
                      hi
                      system info
                      model dvb-xc ex5100 tda
                      s/w 1.0 st4 jan 16 2009
                      h/w 2.0t k5 +D
                      bootstrap v001
                      s/w build kuro

                        Comment

                        • danamite5
                          Newbie
                          • Mar 2010
                          • 14
                          #7
                          hi satsmo heres my sytem info thanks mate!
                          hi
                          system info
                          model dvb-xc ex5100 tda
                          s/w 1.0 st4 jan 16 2009
                          h/w 2.0t k5 +D
                          bootstrap v001
                          s/w build kuro

                            Comment

                            Previous template Next
                            Working...