Eurovox Max V and DarX firmware problem

[RustyMG]

Hi all.
As I type its Tuesday evening, and Ive just updated my Eurovox Max V Black with the DarX firmware.
The flashing went fine, but when I connected the box back up,m I get a "no signal" message, and when I go into the Languages & hit the yellow button to bring up the code entry page, its totally blank - no provider or keys present - has there been another update rendering this firmware useless ??

[Cable Baron]

what i suggest is you update your channels via the menu or do a powerscan. my box is working fine now after the firmware update, and i've just checked my code entry page and it is blank too.

[username]

I haven't installed any new firmware into my box (do not have equipment and al the know how to do so), but I updated the key 2 days ago and it's still working have I missed something.

[davieboy.rfc]

hi ive also tried doonlooding the max v firmware but it wont go on to my box any ideas as ive not had any probs before.

[Cable Baron]

hi ive also tried doonlooding the max v firmware but it wont go on to my box any ideas as ive not had any probs before.

When you load the firmware and click the download button does it recognise the box i.e. does it say sending?

[RustyMG]

Cable Baron - I uploaded my channels to the pc, downloaded the firmware to the box, then downloaded my channels back so I would have all my favourites in the right place etc and wouldnt need to rename just about every single channel - the exact same procedure I did with the April update, but this time I got the no signal message as mentioned - once you upgraded your firmware, what exactly did you do next ? What scan options did you use?
Cheers in advance.

[davieboy.rfc]

when i load the ufl it says waitng for response of your receiver it did that before then afer a few secods it would load but not this time any ideas m8y.

[PVR5000]

when i load the ufl it says waitng for response of your receiver it did that before then afer a few secods it would load but not this time any ideas m8y.

Check to see that your R232 cable is connected properly and also you selected the correct COM port.

[davieboy.rfc]

i checked m8y changed the com port & turned the box of 2 clock setting & it started to doonload just wain now 2 locate a transponder ,thanx for ur quick response.

[Cable Baron]

RustyMG, if you have your cdf file saved on your pc, then i suggest you go into the menu and go to the config menu and click clear data. your want to clear all channel data, then do a full powerscan. once this is done see what channels are on. it maybe that your current cdf frequencies aren't correct anymore so that's why it says no signal.

[macawey]

Hello someone,
Have downloaded the latest software for my Blue box and program confirmed download had been successful. When I plug the Eurovox back into the TV it states 'No Signal' on the screen and showing error on box I have tried reflashing the box on several occasions and each time it says it's been successful but I still get the 'No Signal' tanks

[dangerousgangsta]

Does the green light come on the box, when the box is out of standby?

[camelv]

Hello someone,
Have downloaded the latest software for my Blue box and program confirmed download had been successful. When I plug the Eurovox back into the TV it states 'No Signal' on the screen and showing error on box I have tried reflashing the box on several occasions and each time it says it's been successful but I still get the 'No Signal' tanks

have a good read throughthis thread m8

http://www.digital-kaos.co.uk/forums/f71/eurovox-max-2006-non-clone-problem-led-34099/

also try to factory reset your box select the correct symbol rate and press ok to power scan