Hi
I have 3 boxes in total. Signal from outside the house goes directly to the The Box which works fine. The other wire from outside goes into a 2 way splitter and then out to 2 boxes which are both The BOX USB.
Problem is that these 2 boxes are either missing the odd channel after a scan and factory reset or they scan the channels fine and then couple of hours later "No Signal" message appears.
Is there any device i should try to boost the signal?
Also i have a 3 way splitter as well which i assume would make my signal weaker than the 2 way splitter i am using.
Finally it says "Power Pass" on the 3 way splitter between one of the OUTS and the IN. What does this mean?
Any answers will be appreciated
I have 3 boxes in total. Signal from outside the house goes directly to the The Box which works fine. The other wire from outside goes into a 2 way splitter and then out to 2 boxes which are both The BOX USB.
Problem is that these 2 boxes are either missing the odd channel after a scan and factory reset or they scan the channels fine and then couple of hours later "No Signal" message appears.
Is there any device i should try to boost the signal?
Also i have a 3 way splitter as well which i assume would make my signal weaker than the 2 way splitter i am using.
Finally it says "Power Pass" on the 3 way splitter between one of the OUTS and the IN. What does this mean?
Any answers will be appreciated