F3 Stuck on load

[slik444]

HI

can anyone help me

i added the new AJ LIst channels (no Adult)

and my f3 has been stuck on load

can anyone help me

thank you

[mahrkpat]

Try unplugging and wait 5 mins.
If that does not work read this thread recover dead openbox.

Also this tread is of interest skybox f3 can't....

[slik444]

thank u

just reading up 25 pages atm

[slik444]

my box is still not working any help ?

[mahrkpat]

my box is still not working any help ?

What have you done so far?

[slik444]

Iv downladed Upgrade_PVR800 HD Tool various diffremnt dates with teh altest dated one and the latest frimware and still has not changed anything just stays on

syncronising STBs....

Please reset target which i ahve done plenty of times and still no change

[slik444]

iv literally tried the old softwares to the latest

[slik444]

any help would be much appreciated

[mahrkpat]

If your cable etc.. is ok then if you feel confident enough open up your box and look at the circuit board where the rs232 port is connected make sure there are no loose connections (dry joints) or too much solder causing a short this was a fault someone else had.

[slik444]

If your cable etc.. is ok then if you feel confident enough open up your box and look at the circuit board where the rs232 port is connected make sure there are no loose connections (dry joints) or too much solder causing a short this was a fault someone else had.

its happnedwith both of my boxes as i updated teh new AJ channel list thru USB