Technomate TM 1500

[telveskid]

Hi Guys,

Just set up a dish for 39east but i cant Lock on to the Sat was asking is Latest Softcam still working before i get Sat Installer to lock the Sat Down for Me ?

Kind Regards

[mdt]

Hi Guys,

Just set up a dish for 39east but i cant Lock on to the Sat was asking is Latest Softcam still working before i get Sat Installer to lock the Sat Down for Me ?

Kind Regards

hellassat2 is low on the horizon and a off-set dish appears to be looking downwards when on this bird. make sure you are using an active transponder like 12.524.H.30000/12.565.H.30000/12.685.H.30000 to find the satellite. the latest softcam is still working and should have the next key in it aswell. check there are no line of site obstructions like tree,s ect and set the dish elevation at 25 degree,s and the skew at -47(from in front of the dish turn the lnb clockwise) move the dish very slowly left to right and ajust the dish elevation slightly and try again. hellassat2 is a powerfull bird and you shouldnt have any problems using a properly set up 80cm and good lnb, regards mdt

[telveskid]

hellassat2 is low on the horizon and a off-set dish appears to be looking downwards when on this bird. make sure you are using an active transponder like 12.524.H.30000/12.565.H.30000/12.685.H.30000 to find the satellite. the latest softcam is still working and should have the next key in it aswell. check there are no line of site obstructions like tree,s ect and set the dish elevation at 25 degree,s and the skew at -47(from in front of the dish turn the lnb clockwise) move the dish very slowly left to right and ajust the dish elevation slightly and try again. hellassat2 is a powerfull bird and you shouldnt have any problems using a properly set up 80cm and good lnb, regards mdt

Thanks i,ll give it a Go Am actually using a 1 metre dish was getting Turksat @ 42east SO you say the sKew is that the gauge on the LNB ?
turn that Clockwise.?


Am also using a Satellite Bleeper with the Needle 0-10

Regards

[mdt]

Thanks i,ll give it a Go Am actually using a 1 metre dish was getting Turksat @ 42east SO you say the sKew is that the gauge on the LNB ?
turn that Clockwise.?


Am also using a Satellite Bleeper with the Needle 0-10

Regards

forget the sat bleeper.... set your stb to one of the txp,s i suggested and use the SS/SQ bars on the osd. if your getting turksat you should be ok unless there is gap in tree,s ect. find turksat again then move the dish to the right(from behind the dish) slightly and slightly upwards/downwards to peak the signal. regards mdt

[telveskid]

Thank For Replying

The Dish is on a Flat roof with Surface Water so am reluctant to get a TV & Technomate box up their at moment.

I made the mistake of fitting an Motorise but realised the latttiude in the motor memroy was at different address to where the motor is being fixed now.

i started at 1 west and moved the dish eastwards however the dish was pointing at 5pm & 28.e
lets say is was listing more than the ship( so ive took the motor off reset its memory) and will find 1 west again then more it slowly eastwards storing each satelitte in turn.

i should be ok that way do you agree mdt ?

Many Thanks Mate