Re-setting technomate 5400 box

[humans first]

Guys: After managing to screw up my previous box I opted to buy another. I re-installed it fine and it's picking up 13E with a good strong quality signal. I input the latitide and longitude co-ordinates and, using USALS, attempted to move the dish to point at 1.0w. Buggar me I can't find it! I've deleted the limits on the motorised setting and have attempted to fine tune but still can't get a proper signal.

Anyone got any clues?

[Manic01]

You need to set up on 1w first.
Use dishpointer.com

[dick b]

as manic01 has said.try this guide(the usals bit)

[humans first]

Fellas> The dish was set up previously and sits happily on high up on my wall to avoid local trees. I don't want to mess about up there fiddling with the dish itself. I had it set to 1W before I screwed up my previous box. All i've done is replace the STB but the dish was obviously pointing to 13E when it was last used so I can see 13E no problem but I need to point it at 1W (I believe) to get the thing moving in the right arc (I think)

I'm sure I did this previously using Disecq 1.2 but can't bloomin remember how I did it.

Any ideas?

[celticnthell]

Send the motor to zero m8 with the usals settings in the usals settings. then drive the motor to all other sat's and see how it go's m8.