Tecnomate TM-1000CI software upgate

[AKB990]

I have updated the software of my Tecknomate TM-1000CI receiverer to ver.196 from Tecknomate webpage and now it is not working.
Can anybody help.

[thijs]

I have updated the software of my Tecknomate TM-1000CI receiverer to ver.196 from Tecknomate webpage and now it is not working.
Can anybody help.

not working in what way did you flash the box
by starting with backup channellist
then factory reset >load original firmware (also on tm site)>fac.reset>load patch>factory reset>put back channel list>
rescan all sat's

[AKB990]

Thanks for reply.
What I did I downloaded Receiver Software Loader TM loader TM-1000-5000-6000 and Receiver Upate Software TM-1500CI+TM-1000CI from TM webside and dawnload software to my receiver.
Now when you swich on the receiver time comes on and then you use the remote to change channel nothing happens.
I would be very grateful if you could guide me to put right. Thanks again

[dick b]

do a forced download.
turn stb off at rear and connect up null modem cable to rs232 port.download either latest patch or official software and unzip.open loader and browse for and load patch click on connect then turn stb back on at rear.wait for sending>erasing>writing>finish box should re-boot and work.

[dick b]

try these

try this loader and patch.dont forget it must be a NULL modem cable.and use the method above.

[solovei72]

Big Thanks

Hi. I wish to say thank you for this helpfully advise from dick b, it help me a lot.