Use OPCOM090821d and use function Clear Deployment Data. Maybe this will work.
Hi, one friend have an Opel Vectra C (ModelYear 2002) with airbag light on.
OP-COM says:
Can I use airbag resetter (clip) to clear SDM-ecu?Code:OP-COM 081016 - PC based diagnostic tool OP-COM - CAN Communicaton Window> 2002|Vectra-C / Signum|Body|SDM (Airbag) Read Info... Identifier: 0x0001 Part Number:13118804 Software version number: 00BA845C System description: DELCO0400 Alpha code: AQ Manufacturing date: 020308 Total number of fault codes: 1 B1000 - Replace Electronic Control Unit (ECU) (00) - Present
Thanks in advance.
P.D.: Car don?t have any crash.
Last edited by djbill; 15th March, 2010 at 11:32 AM. Reason: Car status
Thanks, i will try this.
what do you think about this error (B1000) on airbag ecu?
i thought to clear crashed data from the module which normally locks you need to do it via the chip on the board not obd connection
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
hello
do you have solve the b1000 problem, i have the same
best regards
No, sorry.
You need flash clear crash file on chip. Maybe Airbag resetter will work but i don't know.
Regards.
Hi, I have the same problem, there is also error on other modules that is no connection with airbag module, after clearing the dump of 95040 airbag light goes out for some seconds and then back on, in the time that the light is not on the diagnostic connection is possible, after that module dies again, when turn ACC off and on again in a minute or two the module lives again for some seconds and dies...
I need full flash of the processor 0K75F (912D60) to compare with my one
13129843 CL
thanks but I don't need this, already tested with good dump for 95040, I think the problem is in processor that's why I want to compare the full flash for motorola with good one...
Bookmarks