Engine Issues on VW PASSAT B6 2.0TDI

[vilijonas]

Hello,


Recently, I underwent an engine swap, installing a previously operational engine from another vehicle into my own. The engine in question is a VW PASSAT B6 2.0TDI with 125kw, ECU Siemens PPD1.2.


Upon completing the swap, I encountered a series of problems that have left me puzzled. The engine starts, but it exhibits a noticeable roughness and instability. Additionally, the RPMs do not rise beyond 4000, giving the impression of the engine being in a "limp" mode.


I have taken a systematic approach to troubleshooting this issue. I initially adjusted the injectors before starting the engine. Despite meticulous adjustments, the problem persists. It's worth noting that the injectors were professionally refurbished and reinstalled.


To rule out any mechanical issues, I conducted a compression test on all cylinders, and the results indicated a healthy compression level of around 25 bar in each cylinder. This suggests that the cylinders themselves are in good condition.


Using VCDS, I monitored the injector values (engine bank 13), and the readings have been quite perplexing. Injectors 1 and 4 seem to be operating correctly, but injector 2 displays a value of -1.8~, while injector 3 shows a value of +2.6~. I have physically swapped injectors multiple times, and yet the values remain consistent.


Curiously, the ecu does not display any fault codes, which adds to the mystery of this situation.


I have attempted injector adaptation through VCDS, hoping that it might rectify the issue, but unfortunately, the problem persists.


Given the complexity of this problem and the various steps I've taken to address it, I kindly request your expertise and guidance. Could there be a specific programming or coding issue related to the injectors that I am overlooking? Perhaps there's an aspect of injector calibration or ECU interaction that requires attention?


I genuinely appreciate your time and insights, and I am open to any suggestions or recommendations that you may have. Your assistance in helping me resolve this issue would be immensely valuable.

I forgot to mention that EGR and DPF are disabled. The DPF was removed before the engine was replaced and remapped ECU file was reflashed before attempting to start the replaced engine.

Thank you for your attention and support.