Reply With QuoteYou need to lever it carefully and with a scalpel cut the sealant. Heat the case with a heat gun so it gets softer.. Not that easy but doable.
And yes eeprom on the opposite side of the mcu.
Results 1 to 6 of 6
Thread: Bosch ME7.4.5
-
26th March, 2010, 04:02 PM #1Top Poster
- Join Date
- Aug 2009
- Posts
- 168
- Thanks
- 15
- Thanks
- 9
- Thanked in
- 7 Posts
Bosch ME7.4.5
Hi, i need to swap eeprom from dead ecu to new one, but where is 95320 ? on MCU side is no eeprom. on other side how to reach ?
thx
-
26th March, 2010, 04:21 PM #2DK Veteran
- Join Date
- Dec 2009
- Location
- London Middlesex
- Posts
- 1,264
- Thanks
- 128
- Thanks
- 47
- Thanked in
- 33 Posts
Whatever seems impossible is just not yet important enough.
-
26th March, 2010, 04:55 PM #3Top Poster
- Join Date
- Aug 2009
- Posts
- 168
- Thanks
- 15
- Thanks
- 9
- Thanked in
- 7 Posts
Thank you very much, i finally manage to remove board. But had to desolder conector , WUF thats lot of work, Do you remove board without desoldering.?
Regards
-
26th March, 2010, 10:53 PM #4DK Veteran
- Join Date
- Dec 2009
- Location
- London Middlesex
- Posts
- 1,264
- Thanks
- 128
- Thanks
- 47
- Thanked in
- 33 Posts
No need for desoldering mate. The black connectors comes out with the pcb in one go. You need to lever on the corner and then cut the glue..
TaWhatever seems impossible is just not yet important enough.
-
5th April, 2017, 03:14 AM #5Member
- Join Date
- May 2016
- Posts
- 97
- Thanks
- 32
- Thanks
- 9
- Thanked in
- 9 Posts
why ecu was dead? pulses fail on bobine of car? thx
i have a car with pulses fail on four cilinder and when i open the ecu it has the same colour that yours around the pins.
-
5th April, 2017, 04:57 AM #6DK Veteran
- Join Date
- Nov 2016
- Location
- Inside my clothes
- Posts
- 2,354
- Thanks
- 566
- Thanks
- 2,122
- Thanked in
- 1,266 Posts
eeprom virgin 95320 for 7.4.5
Bookmarks