Renolink Clio 4 Coding DLR enable but have problem now

[antonis132]

1696241182947.jpg1696241182991.jpg1696241183031.jpg1696241183071.jpg1696241183101.jpg
Hi i have my Renault Clio model 2015 1.5dci, i was trying through renolink enable my front drl lights because i had no volts when i check before bulbs, fuses before coding. After succesfully coding i found enable the drl ligths, i enable follow me home and front fog lights which also don't lights. Fog lights were diasbled. After these none of these working and i have fault on upc left & right daytime light, left & right front fog lights on diagnosis and Service light on dash and message check brake lights. I delete faults the service light close but after start engine it light again. I disable again through renolink but again the same what can i do? I will upload some more pictures

[antonis132]

1696241183135.jpg1696241183162.jpg1696241183192.jpg
I try again clear faults, repair light off, start engine with clutch not brake, no repair light no message but when i touch brake pedal mesage come check brake lights and repair light. I check brake lights all working. Someone could take photos from another clio with renolink on upc module so as compare the coding, because i think when i enable something there it changes other coding below...

[DarthAnjastis]

Do you fix ir? I have the same problem.

[antonis132]

Yes all fixed by myself, need more time and works great no faults. If you need help with anydesk.