Dacia BCM pinout

[Perryking]

Hello, I need pinout for read this BCM from Dacia.

[Panathaole]

Hello, I need pinout for read this BCM from Dacia.

had you try to read it with renolink???

[Alis1]

Try.......

[Perryking]

BCM is water damage, it wont communicate over OBD. How can I adapt used one?

[carloxgsxr]

I'm exactly the same as you I've been dealing with this for 10 days and no solution.
If you don't read the TL4, you won't be able to get the ISK or the PIN and you won't be able to clone it with Renolik.
I have tried to desolder it and solder it in another BCM ok and it doesn't work for me, it is difficult, there are 144 pins.
The schematic they give you is ok, you just have to put a resistor on the CAN line, pins 3 and 4 or 23 and 24.
If a relay does not enter the endpoint, do not continue because you will not be able to read it.
The solution is very simple, if you read it you can clone it with Renolink, the problem is that you will not be able to read it.

[Mmotul]

Fastest solution: NEW UCH available on ebay, tested ok, price approx 160eur. renault new price 800e

[Mmotul]

BCM is water damage, it wont communicate over OBD. How can I adapt used one?

Im not tested this, but I think Renolink have option to make UCH virgin, and then you can adapt at Renault dealer online ( not expensive)

EDIT: RET also have option to make UCH dacia 2012+ virgin

[rob h]

You can clean the board, and try reading it with programmer.

SC120541VLQ6 / 0N13E
Read as MPC5606B

[lion0304]

It seem MCU locked, fatest solution is: Swap MCU to used doner.

[carloxgsxr]

What cable would I need to do online coding from Renault ASOS + Token
It says that the cable is compatible with SAE J2534.
It does not indicate which one would work for me, I have PCM Flash, Ktag, AMT BST ECU, Diagbox, Renolik,
I think none of them will work for me.
The idea would be to virginize a scrapped TL4 with Renolink and encode it online with pass-thru from Renaul ASOS.
Thank you

[Mmotul]

It seem MCU locked, fatest solution is: Swap MCU to used doner.

Yes, you ae correct, I also think locked to read with programmer, I try to read but no luck. I have a few Renaults water damaged, some times swap mcu is ok, but sometimes dont work (damaged content).

[carloxgsxr]

What cable would I need to adapt the virgin BCM to with Token + Renaul online????

[rafal]

What cable would I need to adapt the virgin BCM to with Token + Renaul online????

Where you found tokens and online for Renault?

[carloxgsxr]

On their website there is asos.renault.com everything is available, what I don't know is what cable
I can use to adapt the Virgin BCM