>>>>>>>>Xhorse Multi Prog<<<<<<<<

**qwojtus** · 24th April, 2024, 06:37 PM

Cas 3 R/W very lottery. Sometimes read in a sec, sometimes never read. I tested many I don't really understand.

EDC17C84 traffic read good Bench mode

MQB NEC D70F3526 - no way read with xhorse adapter. Just adapter fault. Lifting leg read and write fine.

**sniegavirs** · 29th April, 2024, 11:26 AM

Originally Posted by qwojtus

MQB NEC D70F3526 - no way read with xhorse adapter. Just adapter fault. Lifting leg read and write fine.

Just did 2 x MQB NEC D70F3526 Virtual Dash with adapter - Worked perfectly. Your problem could be the adapter.

**BadeaCristian** · 29th April, 2024, 11:54 AM

PCR 2.1 read/write flash in bench ok...with online Checksum , also eeprom read ok

**sv2hqx** · 29th April, 2024, 01:54 PM

EDC16C39 cant read
connection error

**qwojtus** · 30th April, 2024, 07:41 AM

Originally Posted by sniegavirs

Just did 2 x MQB NEC D70F3526 Virtual Dash with adapter - Worked perfectly. Your problem could be the adapter.

I did virtual dash with KTP and adapter and worked fine too.

Maybe adapter faulty, maybe adapters are lottery, but wasted over 1h rather lift the leg and do it correctly.

**sharpshooter86** · 2nd May, 2024, 08:31 AM

SRS-VW20(SPC560P50L3) Can't read
Initializing device... DB44 interface inserted

Pin configuration completed

Sending algorithm file...

Chip power configuration modified successfully!

Chip power turned on

Querying chip basic information...

Chip connection failed!
Ending process

The chip power has been turned off!

**Automods** · 4th May, 2024, 09:55 PM

Can't for the life of me get it to read CAS3+ using the original MCU Adapter, I have a few CAS3 units here and on one ocasion I was able to read the flash once but that was using the XDPG02EN V3 reflash cable and the multi adapter.

I am certain this is a cable/adapter fault relating to the clk coax, between the CLK and screen there is only 3 ohms resiatance.

There is also an issue with reading Jaguar SID20X ECUs, they have the wrong flash shown in the software,

**sharpshooter86** · 5th May, 2024, 05:56 AM

Originally Posted by MACKIE

Any news about the cable for RH850 ?

Regards
Mackie

https://de.aliexpress.com/item/1005006686925735.html

**rayssant** · 5th May, 2024, 04:55 PM

whats with mqb milleage correction multiprog + vvdi2 will be able to do it?
and what abaut immo transfer from analog cluster to digital?

**darknezz19** · 7th May, 2024, 11:51 PM

MSV80 read int eep and flash on platform bench mode ok. Boot mode wont connect, and is needed for checksum correction and ext eeprom reading/writing. Ended up reading ext st95640 out of circuit, reading in circuit will not give a valid read.