Help with Denso 33920-69E9 0 ECU from Subaru Justy 1.3

[derbisch]

Hey there!
I'm trying to set up a CLIXE IMMO OFF SUZUKI 2 by CARLABIMMO, for which I need to change 4 addresses (4 - (incl.) 7) on the 93c56 EEPROM of the ECU (Denso 33920-69E9 0).
I successfully managed to change the values with an arduino and the M93Cx6 library, however, I think the values in address 2 and 3 got changed, too and I'm wondering what they are used for, or whether they're correct. Can somebody help / tell me? I checked some other dumps of this ECU in this forum, some had "00" in those addresses, some use "FF", but both seem suspiciously generic (?).

I'm completely new, so feel free to tell me anything that could help or could be obvious but a reason for the problem

These are the values after my changes (I hope this helps):

address 0: 0 (does this make sense? what is this used for in the ECU?)
address 1: 0 (does this make sense? what is this used for in the ECU?)
address 2: d0d (does this make sense? what is this used for in the ECU?)
address 3: d0d (does this make sense? what is this used for in the ECU?)
address 4: 33 (needs to be set like this according to manual)
address 5: 33 (needs to be set like this according to manual)
address 6: 33 (needs to be set like this according to manual)
address 7: 33 (needs to be set like this according to manual)
address 8: 0
address 9: 0
address 10: 0
address 11: 0
address 12: 0
address 13: 0
address 14: 0
address 15: 0
address 16: 0
address 17: 8
address 18: 3882
address 19: a405
...

Thanks in advance!

Link to IMMO OFF emulator:
https://carlabimmo.de/p/clixe-suzuki-2-oder-immo-off-emulator

Link to pdf manual (see only page 5):
https://carlabimmo.com/clixe-manuals/immobilizers/suzuki93c56/suzuki-93c56.pdf