I have problem with reading mb esl does someone have working solution for XprogM?? i tried with disconnected pins and unsoldiered mcu
I have problem with reading mb esl does someone have working solution for XprogM?? i tried with disconnected pins and unsoldiered mcu
Hello, mayby Somebody could attach PCB picture of old key with Motorola (3 switches) from other side of PCB, because I was desoldering and third switch has gone out and I don't know where exactly to solder it.
Best regards.
i build adapter, and always desolder mcu from esl. work ok.
this is correct pinouts to program this mcu outside pcb
Last edited by micromax; 14th May, 2011 at 09:16 PM.
mexanico1971 (27th May, 2019)
My xprog work with that schematic but only after i conected pin 8 and 17 to 28,after that working great .
how to vergier my key 0F82B MOTOROLA THANKS
hi
you can read this with orange5 with no problems.
its the same chip in toyota avensis and fiat immos
regards
Pzolee (14th November, 2014)
pıcture have to mc05e6 conect please time out eror
hi i tested this mcu with car prog and not reading pcb of the key mb but i have a immo module peugeot 306 1998 and i put the mcu on this pcb and read/write ok with car prog !!!
Last edited by jhonyelectron; 2nd January, 2018 at 11:30 AM.
WinWoj (27th February, 2019)
I think you need to lift pin 1 before reading
if you want to read and write 68HC05E6 via Upa
Lift 1,2,11,12,15 pins
Upa 68HC05E6
1 -------------- 1
2 -------------- 11
3 -------------- 12
5 -------------- 28
6 -------------- 16
7 -------------- 2
8 -------------- 15
9 -------------- 27
bridge 5 - 27 pins of 68HC05E6 by 1K resistor
5 ---- 1K ----- 27
Bookmarks