Lavman,
Your ECU is a newer model. It is the same ECU Peugeot 307 models 2006 and up have it is a IAW 6LPB.
"I find your lack of faith disturbing"
If you found my post useful, please use the "Thanks" and "Rep" buttons.
Mr. Mac Gyver and all DK Members,
Thanks for your help on this matters. I have managed to read the ST10 from a Peugeot 307 IAW 6LPB using ST Flasher tool.
Yet, I would like to ask a bit more help from you or any DK member.
I need immo off this ECU. If that is not possible then virgin ECU dump to telecode with PP2000.
I am attaching the file downloaded in HEX and BIN format for anyone who can help me.
Thanks again for your help and knowledge.
"I find your lack of faith disturbing"
If you found my post useful, please use the "Thanks" and "Rep" buttons.
Sorry forgot attachments
"I find your lack of faith disturbing"
If you found my post useful, please use the "Thanks" and "Rep" buttons.
gr_diver (26th October, 2019)
Dear Milanooffracing,
I tried to convert the file you kindly sent to me to HEX file and I noticed there is a big difference in size compared to the original one.
Virgin.hex is 1.309 kb
Original file is 1.441 kb
Can someone please help me on how to proceed? Do I fill in just with FF. What banks should be replaced?
I am using ST10 flasher with K line to read and program this ECU.
Thanks.
"I find your lack of faith disturbing"
If you found my post useful, please use the "Thanks" and "Rep" buttons.
magnacin,
the difference in size of the files is as follows:
the last bank of flash memory is not in virgin.hex,
bankt 15 if I remember correctly, it is empty on this type of ECU,
then there is no need to read and write to that bank.
Thanks again Mr. Mac Gyver.
I will try to program as it is and see what turns out. I will let the forum the results sometime next week.
"I find your lack of faith disturbing"
If you found my post useful, please use the "Thanks" and "Rep" buttons.
I want read MCU (st10f280) with xprog.I cant find tx pin,rx pin,reset pin,pol.4 pin,vcc pin and gnd pin in ecu mainboard.Please see attachment picture and sent to me connection diagram for xprog..
036 906 034 KA MAGNETTI MARELLI IAW4TV.KA
thanks..
Try these pictures an probably will help you.
"I find your lack of faith disturbing"
If you found my post useful, please use the "Thanks" and "Rep" buttons.
capi (23rd May, 2019)
Hi, I need virgin dump MM6LPB for Peugeot 307.
The dump of Milanooffracing dont work..
the file...
Thanks in advance
please can you help me for program this calculator 6LPB not 6LP2 .I compare between this calculators and i find the difference in shematic electronique.
can you help me for pinout xprog for 6lpb in this picture i put it
thanks in advance
Any help please...
Hello .
I have a problem with read/Write MCU (st10f280) with xprog m .I cant find tx pin,rx pin,reset pin,pol.4 pin,vcc pin and gnd pin in ecu mainboard .
The board is similar like in the picture ,but I did not where to conect . THE ECU is 6LP1.50 .
Bookmarks