PLEASE . help me ecm cummins N14 . faul code 352 . ZkTcyxl.jpg . revised harness and the correct voltage 5v, correct ground return. which can be within the ecu?
PLEASE . help me ecm cummins N14 . faul code 352 . ZkTcyxl.jpg . revised harness and the correct voltage 5v, correct ground return. which can be within the ecu?
May be some pressure sensor do it short to ground
Last edited by Roy Suryadwiananda; 2nd May, 2016 at 05:33 AM.
Das any one have Cummins Insite PC ID 8858F5D6 Verification Code 1C4D7-847D2 Build vertion 7.6.2.240 SPS Password ?
Dear friend,I have two ECUs CM570.They were on ISX engines and I recalibrated the both for ISM engines.The both have DTC 323,fault for 5th injectors,but in insite on cut out test all inejctors work,but fault is active.ECUs did not have problems and faults on ISX engines.Communication lines work fine.Please help.Thanks in advance.
ISX don`t have connection on the 03-04 pins(inj5 on the ISM). ISX 03 pin- priming pump return no diagnostic code. May be internal defect ECM control injector 5.
Hello friends, I have ECM Cummins ISX P/N 3408501, Water entered the ECM and the engine will not start and communication with INSITE is flawed, to revise find myself alone on the big green 12v capacitors, I know it must have 130v in these capacitors, any suggestions please .... I have 3 days reviewing but can not find the fault ..IMG_20160601_153017.jpgIMG_20160601_152954.jpg
Thanks
Hi.need help i have celet Plus ecm for n14 this have fault code 111.how program the memory to solve the problem
colh (23rd July, 2016)
Hello, I have a cummins CM570 ECM just as the one Jhon Silva had, the same problem, water inside. and truck doesnt start anymore. Cant get high voltage on green capacitor, and cannot communicate with insite. no visual damage to components, Any ideas on how to repair? thanks!
Hi, anyone have schematic for n14 celect plus ECM
ive seen engine brake wire harness short out before the jake and cause issues with ambient air and crank sensor which takes out capacitator inside ecm. also a bad batery connection will cause issues too.
replace ecm cheaper than going thru ecm
Bookmarks