ok I will try calterm
yeah the recalibration most correct the problem,because or maybe u dont have a physical component damage,also u can connect with calterm,upload the calibration,after that disconnect to ecm and open the cal file ,and select paramters search,edit the clutch switch and dissable,this component its optional ,not al models have it and u can dissable,its how I ve done couple times.
ok I will try calterm
Last edited by mondao; 12th July, 2010 at 02:04 AM.
you can go for service center, where did u live, just tell me your location , i will give you the service center addresses, i think they will help you easily and you can further ask any other problems...
yeah .we..go to the service center....and close the thread
I don't think that going to the service center is the solution of the problem, the service center in my county is 200 km from where i leave, the point of this thread is to share solutions on how to to repair ecm by your self.
sorry to say but I can not do good work with (calterm)
maybe can give a different use for this (ECM) in another application,maybe generation,
if anyone has an idea, (I have little imagination) sorry mates
calterm ...at iquals to dct ...works in all cummins ecm?s and u can do anything...something special!!! u need to upload and change parameters after that download.
thanks I continued trying to learn a little before sending a calibracion
to download a calibration ...in a programed ecm its not so difficult just send...but for a new ecm or blank one u need to make bench cables.
my problem is solved now, thanks I went with a cummins dealer and a new one is
post closed
Last edited by mondao; 14th August, 2010 at 08:54 PM.
calterm...works with same connectors ... differences with insite ..its the bbot mode ...necesary in new ecms...and special for it are bench cables...the other funtions like read ,delete fauil codes,edit parameters and aply changes in the ecm ?s cal all possible with inline...in the 3x vercions I think its possible to with usb link,dpa4,noregon or rp1210a
Last edited by hercamp; 28th September, 2010 at 07:12 AM.
hi guys i have a litle problem with ecm celect P/N 3618046, this ecm have the active code 351. Injector power supply below specifications inside ECM.
This code to appear together with 434 code. i found problem in power supply to ecm. I repair it, and 434 code go to inactive but 351 still active...........Does someone know as repair this?
thanks in advanced.
HI
Are you getting 100volts on the big green capacitor? If you check just behind your actuater harness you will see surface mounted transisters in between two heat sinks,they should be six in number,check that none of them have a shot circuit,if so replace and that fault code should be history.
Bookmarks