Please precise insit + 6.7 kg
Please precise insit + 6.7 kg
Hello,
I have a celect plus ecm that will not take a cal, even after rom boot with a bench harness. I noticed that the bootloader version box is blank in Calterm when I am connected to it. Is the bootloader available as a file, and can it be reloaded into the ecm?
Thanks!
HP
Donniemnemonic,
I used calterm unlock, found status was 1DOA. I changed it to 5EED, then to 600D, turned the ignition off for 30 seconds, then back on and much to my amazement run location is now default and the original cal file and parameters are back!
Thanks!
HP
BUSCADOS (2nd November, 2023)
Hi Hpcummins
Glad you got it working again, though I can't take credit for that you figured that one all on your own. Seems the more we play around with calterm the more we seem to learn.
Did not even realise that it was possible to revert to default and regain full operational functionality from Romboot without having to recalibrate. Nice share m8.
Do you know if there are any E2m files for celect ecms besides the ones posted here by Jctech cause all the ones here do not display the correct ecm part and serial numbers. Unlike the celect plus ecms and so I am not sure of the accuracy of the information uploaded from celect ecms.
Regards
Donniemnemonic
I need rom boot mode schematic for QSK19 ecm part No 3867743
Please any body help me
Best Regards
hello , I have a ECM of ISC/ISL whit the following problem , INITIAL FOOTPRINTED, how i can do to reprogram it
plesas help me
I need rom boot mode schematic for QSK19 ecm part No :3867743
Please some one help me
Best Regards
Hi m8sThanks for the e2m file you posted Hpcummins. Have tested it and still reading the wrong part and serial numbers. Tested with P/N 3618046, 3619037 and 3084473.Does anyone have an e2m file for these part numbers that works correctly? Please post if any.The Cell please post the celect e2m files you have.RegardsDonniemnemonic
Bookmarks