w211 key dump

[drivesure]

i have 2004 C200 A/T merc with no keys. i read the ecu me2.0 with 29f800bb attached and eis with single motorolla mcu HC112. dump attached. could anyone help to genarate a key file i can load onto a nec chip of the key.

thanks

[DJAMY]

hi
im new come here
i can generate for you keys
with my solution you have to virgin 29f800 and EVL
and procedure with star in dev mode
after start engine
with wich tool are you programming NEC , ?
send files again to pm
otherwise wait until i post some thing

[dilick]

i have 2004 C200 A/T merc with no keys. i read the ecu me2.0 with 29f800bb attached and eis with single motorolla mcu HC112. dump attached. could anyone help to genarate a key file i can load onto a nec chip of the key.

thanks

skype me or PM I can help you

[DJAMY]

here is your keys generated

[drivesure]

Thank you Djamy. i have nec key programmer and can add the key info ontu the chip. how do i vriginise the 29f800bb ecu dump? i have star diagnose but did not install it yet. bought from china and received last week but did not install yet. thanks for the help so far. this is my first merc to do. i received a lot of good replies from people using equipment from www.noimmo.lt but their support to me is pathetic. andrew dont reply to emails i sent. i have mbkeyprog2 but the software cannot recognise my ecu dump. he want to charge $300 usd for key dump from eis.

[DJAMY]

ok i will help you step by step
make this keys, i generate for you midlle save , if need i generate last save , with your new calc , key turn iginiton at the 05 time

virgin EVL , and succes to make keys
intall your DAS , you must need it
final step i help you for the ECU
tips
best MCU key NEC for programming is 567897061

[Ne0]

If you problem not resolved - there is your eis dump + dumps for new key's (1-8 generated) , esl (electric steering lock) dump and renewed A271 ecu flash (you have siemens/vdo ecu A271 kompressor - not me2.0 !)
write back eis dump, erase esl with mbprog2 and write recalculated dump, write back flash to ecu - you can do it not only with programmer - you can use galleto interface and write over k-line... then personalize/activate ecu, and set coding if needed (in few situations ecu can lost coding , after renew/ repersonalization/activation ...)

Regards,
Ne0

[drivesure]

andrew from noimmo , gave me key dump for my car. will try that first. thanks will post when tested.