u can sent me the file for you instrument cluster, i can edit for u
I've encountered a Mercedes W211 E240 2003. I've tried to read the dump of the EIS to make a new key using Xprog-M but I've selected the wrong type. It is a HC912 3K91D mcu but I've selected 9S12 type, when I use back the correct settings the flash & eeprom is already corrupted (all FF).
So I've use another backup full dump from another car done previously to recover this car. I've used another W211 E240 ECU eeprom, EIS flash + eeprom to remake the key. I've edited the VIN number to match the car I'm doing.
Now the car is able to start and I've erased all other fault code and do all the neccessary coding to SRS. Everything is fine now but the problem is the mileage section no numbers at all!
May I know what should I do to make the mileage display as the EIS and ECU dump are from another car and VIN was edited to match this car?
u can sent me the file for you instrument cluster, i can edit for u
You must change mileage on DASHBOARD to any mileage in range 0-200 km.I make usually 0. After that You can make Dashboard-EIS adaptation with STAR DIAGNOSTIC. And mileage from EIS will come to dashboard.
Last edited by jevgensolo; 27th October, 2010 at 05:22 AM.
May I know what tools to be use to change mileage to 0? If I use normal eeprom programmer to program the chip soldered out of Instrument Cluster and use hex to edit it is it ok? I've Tachosoft Mileage Calculator cracked downloaded from this forum. I've checked it is only able to let me edit until 100km but not sure how to do it to zero.
Hallo guys, have similar problem .. a coustomers changes the instrument (tacho) because the original was stollen...
not just show ---- instead of the km...
What the way to got... can i solve this problem using STAR ? or do i have to desolder some chip ... in order to make the tacho virgine (km 0-200) and programm it new?
Can someone make the Dump virgine when i read out.. ? and what chip to read?
24c17 eeprom
write chip under 200 km and learning to eis
print or write down original coding and mileage
put all line mileage 24C17 to FF
go to star , dashboar
make adaptation
folow instruction
at the end you will see ame mileage in EIS
by the way if you bring other file from car , you must modifie VIN number to original VIN , otherwise you will got
trouble fault in SRS (air bag) , in ESP and SBC
take care
so i can just use tacho pro to make km to 0 and the code it ? right .. no need to desolder the chip and change the vin by hand?
yes that what i mean ..
Today i had a problem and wanna chare it with you...
One guy tryed to make tacho on the E-Klasse W211 2003 .. he killed the EZS by reading with rosfar clone..
then he got dums of other ezs.. and adapted ecu and esl .. and keys .. to that ezs dump..
he also made the ezs virgine.. so we could code it.. no vin and 0 km..
the ezs was coded... car started but in tacho we just ----
we tried everything.. but still ----- then we though maybe some idiot flached tacho before.. and we made tacho to 0.. and then everything was ok...
clauberty (26th January, 2016)
hi
write the brightness zone all to FF
make adaptation with DAS
thats all
display will dispaly sure
Bookmarks