Tech2 32BM card Memory Card Explorer

**JandJSpeedShop** · 11th December, 2012, 06:34 PM

Originally Posted by zcc

When I run MCE I have this error message and it quits after I click OK. No matter what parameter I change.

I get the same error on 2 laptop on tried this on. One was an older Panasonic Toughbook and another an old Sony Viao. Not matter what parameters I changed the software would not load?

Please help?

**bonecrusher** · 11th December, 2012, 07:36 PM

No problem, just unzip this file click on it then restart. and you good to go and please report back.

If it works don't forget the thanks button !

**JandJSpeedShop** · 12th December, 2012, 12:01 AM

Originally Posted by bonecrusher

No problem, just unzip this file click on it then restart. and you good to go and please report back.

If it works don't forget the thanks button !

Tried that but it didn't work for me

**MJRVR** · 14th December, 2012, 08:52 PM

Originally Posted by JandJSpeedShop

Tried that but it didn't work for me

Have you added these lines to your config.sys file?

device=c:\windows\himem.syys and
device=c:\windows\emm386.exe noems x=d000-d3ff

Dont forget to reboot

Sorry if youve already done this but i havent read all the thread.

Martin

**JandJSpeedShop** · 15th December, 2012, 06:03 PM

Originally Posted by MJRVR

Have you added these lines to your config.sys file?

device=c:\windows\himem.syys and
device=c:\windows\emm386.exe noems x=d000-d3ff

Dont forget to reboot

Sorry if youve already done this but i havent read all the thread.

Martin

Martin,

I did not add that because it said it wasn't necessary with windows xp sp2. I will try it just to see

Thank you