FINALLY IT WORKS!!!
Basically what you need to do flash the memory manually, using the ARM's software.
MY PROBLEM: I briked my china mvci device after using the Firmware udpdate tool, changing the firm. version from 1.4.1 (default) to 1.4.7
MY SETUP: Windows 8.1 64 bits.
SOLUTION:
STEP 1: Download the hex file attached.
STEP 2: Download Flash Magic (my version is 12.80 - build 5762)
http://www.flashmagictool.com/downlo...l&d=flashmagic
STEP 3: Connect the mvci device to an USB port
STEP 4: Open Flash Magic, select LPC2119 (LPC2000) in the field
device
STEP 5: Select the serial port: my serial port was COM3, try to remove the mvci device and plug it again to see if the FlashMagin detects the COM port automatically (maybe is better to remove all others USB devices during the process (my case))
STEP 6: Baud-rate: I selected 4800, but maybe other (higher) can provide a fast flashing.
STEP 7: In the Firmware panel update the .hex file.
STEP 8: Press the giant button START. The flashing should start, it takes a while (20 min aprox. for me)
STEP 9: When Fash Magin get out of the busy state, the process is finished, close the software and remove the device of USB port.
To confirm that it was restored to 1.4.1 version open the HDS driver Firmware Update tools and check the firmware version.
Again, work for me! Good Luck!
Bookmarks