Corsa C Easytronic Problem

[rukass]

Hi..

I have a problem with the system EASYTRONIC, in corsa C 2001 1.2 z12xe, which shows F in the display, and the car stops working.

not show any error in the engine or the easytronic.

I think it is a problem of the actuator, and would appreciate if someone has some information to repair

Thanks

[digi-dash]

i had one that turned out to be reverse or brake light bulb....strange but true. regards steve

[rukass]

i had one that turned out to be reverse or brake light bulb....strange but true. regards steve

yes, this car has been towed several times because of blown bulbs, but unfortunately now has a bigger problem!!

thanks for help

[Meat-Head]

EASYTRONIC, in corsa C 2001 1.2 z12xe, which shows F in the display

Let us know what it was and how much it cost you and how long it took to repair

[Ashraf6119]

i had one that turned out to be reverse or brake light bulb....strange but true. regards steve

Yes his right check also if the Brake Light Switch is Working.
But, most of the times its those two motors which are on the Gearbox they do give problem try tapping them gently and see if that F fault clears and lets you to start the vehicle.

Ash

[Meat-Head]

most of the times its those two motors which are on the Gearbox they do give problem try tapping

Could be baulk rings in furry box making motors draw excess currants stopping it working.

Bad earth to module on box, bad pos - ALLSORTS of things and they stop working.

[Ashraf6119]

Could be baulk rings in furry box making motors draw excess currants stopping it working.

Bad earth to module on box, bad pos - ALLSORTS of things and they stop working.

MH,

At this age Corsa C 2001 you looking at Carbon Brushes in Motors worn out.

Ash

[Meat-Head]

MH,
At this age Corsa C 2001 you looking at Carbon Brushes in Motors worn out.
Ash

Maybee, but has it been used by Petula Clarke just to go downtown. Or has it been used by Roy Oberson who just drove all night on the motorway? Like a dynamo or starter or dynastarter it may have been replaced already!

There is a test flow sheet you can get by *THINK* it's (NO) Luk - whoever makes the system

HTH

Meat

[digi-dash]

check fuses f32 f51 and f54 for continuity and +12v. also ep7 under centre console in car and ep9 near battery for good clean contact, regards steve

[Meat-Head]

also ep7 under centre console in car and ep9 near battery for good clean contact, regards steve

Could you explain in more people for members who are confused what you are refefing to

obd socket batteryy off - do the hokey cokey with your scanner plug

[digi-dash]

ep7= earth point 7, it is located behind/under centre conole (where stereo/heater controls are.) ep9 is near car battery. these will be wires bolted to body of car. remove/clean terminal and car body with wire brush on drill/put back. bad earths are responsible for lots of faults on cars and as the repair is free and easy it is good practice to start with the fuses and earths for 10 minutes before digging deeper, hope this helps, regards steve

[darksawa]

There are some main troubles with easytronic, but first of all you have to read fault codes from easytronic control unit.

[digi-dash]

if still not fixed let us know. several times blown bulbs???? maybe prob in bulb circuits? does easytronic comunicate with tester? if not check power and earths as above. what tester are u using? does it support any live data on easytronic? if sorted please post cure to help others, thanks steve