Hi,
I have found the problem. The fuse for the steering wheel switch module had blown and as the car is VAN bus was preventing the BSI talking to the ECU. The car is now starting 1st time and I am absolutely delighted.
Thanks to everyone for help / suggestions.
I now need to clear the crash data from the Airbag module.
Can anyone please tell me how I go about this?
Cheers
read eeprom from airbag ecu and post here details
in some older post,you mentioned something about :"connector next to steering"...what is that about?
Hi - thanks for response. How do I read just the Airbag ECU module and not the whole ECU? what hardware / software do I use for this please? PP2000 or Galleto?
The connectopr next to steering wheel,i think the software was just saying it had a communication issue with the OBD diagnostic port. This was because the fuse had blown for the switch module around the steering wheel which houses the indicator stalks etc so was preventing the BSI communicationg with the ECU as there was a break in chain...
cool! first you have to see if the cut-off switch is not activated
is a red button that is in the engine compartment on the passenger side
Hold down the button and good luck
Hi
did you make a scan to the ecu and bsi to look for DTC's
try so look for a live data to see if the ecu is locked or not .
God does not play dice with the universe . (Einstein)
if anything can go wrong it will . (Morphy laws)
hay my frind giv my damp 207hdi 1.6 thnaks
Bookmarks