C3 dump correct ??

[DiReCtX]

Hello
After change mileage in dashboard and BSI, car didn't start I check with Lexia in BSI VIN is pppppppppp central lock didn't work too. I check dump original and modified VIN is VF7FCHFXB26078527, PIN is W0WR in it, right??
Can you check is my modify is ok (BSI V1 with NYO), or I must configure with LEXIA BSI again like VIN, keys, etc. every time when change something in EEPROM

[vageric]

try put originel dump back and see if car start!!!

[unu]

Hello
After change mileage in dashboard and BSI, car didn't start I check with Lexia in BSI VIN is pppppppppp central lock didn't work too. I check dump original and modified VIN is VF7FCHFXB26078527, PIN is W0WR in it, right??
Can you check is my modify is ok (BSI V1 with NYO), or I must configure with LEXIA BSI again like VIN, keys, etc. every time when change something in EEPROM

maybe BSI modification file is wrong !
try this one :

[DiReCtX]

hello again I have a problem with the BSI after throwing to dump by @unu the car started, communication through Lexia with other computers such as the engine ECU was, after removing the key for about 30 minutes, the car does not start in the Lexia disappears VIN is only "ppppp .." and sometimes how to disconnect the battery BSI will work but only to remove the key from the ignition, which could be wrong?

[unu]

hello again I have a problem with the BSI after throwing to dump by @unu the car started, communication through Lexia with other computers such as the engine ECU was, after removing the key for about 30 minutes, the car does not start in the Lexia disappears VIN is only "ppppp .." and sometimes how to disconnect the battery BSI will work but only to remove the key from the ignition, which could be wrong?

After you make modifications onto your car , start car , then drive at least 16 km and see/check after that if you have again this issue .
Clear all DTC?s from car .

[DiReCtX]

Hi, unfortunately, continue the same time, the BSI sees the engine ECU and the rest, and sometimes nothing can only see Lexia BSI and nothing more no VIN,ECU, as if BSI did not see 95160 can be corrupted? in XPROG-M reads it without problem, maybe I should try virgin 95160, BSI and try to program, what do you think?

Problem solved, a cold solder on the board