Dash PUNTO 2001

[GP0502]

Hi, I have one problem about Dash PUNTO. On the display I don't have the km, but I have only lines ---- on the display.
How would I get out the DASH damp from the processor?

[maumaumau]

which programmer you have?

[GP0502]

I have x program-m.

[marte690]

You have program a wrong version !

[unu]

Hi, I have one problem about Dash PUNTO. On the display I don't have the km, but I have only lines ---- on the display.
How would I get out the DASH damp from the processor?

bad dump in mcu , or defective mcu ....
replace eeprom areea and then make proxy align.

[GP0502]

Hi, I have a problem. I can't read these dump from the chip.
I've tried read the chip with x.prog but it could not read it.
I have connect it how is draw in the manual. How can I read it in any other way? Thanks.

[maumaumau]

how did the car in that situation ? you work something before display show "----" or not ?the rest of the cluster work well or not? what message show you x-prog-m when can't read mcu ? try to lift pin tx,rx,reset of mcu...

[GP0502]

Hi, maybe someone try to read the km. On the pc when I watch the number of km writte 9999999.
I must read the processor, but I tried on another processor and I burn it. Do you have maybe a sheme or picture, how to connect the processor on the x-prog (the number of the processor is 68HC908AZ32)? And how much must be the voltage + on the processor?

Thanks, bye...

[maumaumau]

read the whole manual...before damage another device...