I have an Xprog-m clone, very good so far, no problems, mainly used for tms374 and a couple of serial eeproms, I've been looking at a bdm100 clone, but noticed I have a BDM adaptor with my xprog-m (P/C 1-002-0017), so instead of buying a bdm100 clone I could just buy a set of adaptors.

But does the xprog-m support everything that the bdm100 supports? Is this the adaptor I need to use for all BDM reading/writing or do I connect directly to the xprog-m without an adaptor? And is there a diagram for connecting the xprog-m to the bdm100 adaptors?

I don't want to buy something that I don't need because something I already have can do the same job!

Thanks,
Rob