MPPS Repair

[e.t.]

Yes, mpps showed 12,6V

I take the optican with the same voltage and its worked!

What`s a print screen?

[e.t.]

Driver ist 6.0.1.0
Date 17.11.2009
Amt-Cartech Ltd

[bobolin4o]

I've a done a tiny patch (needs .net 2.0) that removes the "NO READ" encryption of that version.
Works fine for me!

let me know.

Patch already patched exe, or patch ori exe?

[lulu2003]

it was thought to be patching the patched from scary
will check if it works vice versa or with (later) originals.

[bobolin4o]

it was thought to be patching the patched from scary
will check if it works vice versa or with (later) originals.

Procedure:
1. Install MPPS V5.0.1.10
2. Run Patch MPPS V5.0.1.10 Patch
3. Put in the usb (from interface)and run FirmwareUpdate.Exe then MppsUpdate.exe
4. Finaly interface works

So, if i understand properly, at point 2, must use your patch, right?
And it works with baned serial...

[mishu_b]

...
yes, correct

atb

[lolooo1981]

Procedure:
1. Install MPPS V5.0.1.10
2. Run Patch MPPS V5.0.1.10 Patch
3. Put in the usb (from interface)and run FirmwareUpdate.Exe then MppsUpdate.exe
4. Finaly interface works

So, if i understand properly, at point 2, must use your patch, right?
And it works with baned serial...

Yes,
For 234 and 236 serial this soft work good.

Best regards

[mishu_b]

...
@lo lo oo1981 - it is working for any serial. tested with nice results.

atb

[sepistar]

I just try and always with firmware : devise not found

I've found on the net a C8051f340 to replace mine, i think i'll dont lost time and by this:

MPPS 5.0.1.13 / 8.0.2.10 MCU Repair and update kit

Thank for your help

hi,
how did you solved?have the same issue.have buy new mcu?or tryed something else.
best regards

[sepistar]

so,no matter what i do,have no sn.anymoore it showed 0000000.think the interface are bricked.
best regards

[ecutuners]

so,no matter what i do,have no sn.anymoore it showed 0000000.think the interface are bricked.
best regards

Yes your mpps is bricked

[Multipla]

I installed my mpps and put usb, open the folder, click mpps.exe and when open in video result error: 101 what is this error the operation I have do perfectly. I have a nootebook Toshiba whit XP and first is win7 but I dont like win7 and installed XP any help??? for mee. Tanksssssssssss

[perneo]

And you have use the patch ????

try to put it in C:\Multi Protocol Programming System

ok thanks a will try it.

[omi1980]

My mpps show my good sn with 5.0.1.10 but i have problem with ecu not found k and can .Hou can i go back to 3.0.7???When i plug mpps with 3.0.7 sn is 00000

Windows XpSp 3 mpps alu

[mishu_b]

...
A: you need to reflash with 3.0.2.7 dump.

Q: I have a tool on my hands that shows when I'm trying to read ID to CAN - "Internal hardware error" - anyone else faced with such error?

atb