Suzuki vitara 2004 remote coding

[boss151]

Hello. Anyone knew how to code remote to grand vitara 2004?
Best rgs. from Poland.

[teuton]

Try this:

SUZUKI

VITARA

Procedure
1. Switch ignition OFF and close all doors.
2. Open drivers door and switch ignition on
3. Switch ignition OFF
4. Press and release drivers door ajar switch 3 times
5. Switch ignition ON and then OFF
6. Press and hold each button of the remote in turn for 5 seconds each
7. Central locking should activate
8. Press remote control lock button
9. Maximum of 2 remotes possible

[STAVROS KAST]

GRAND VITARA PETROL

Programming transmitter code:

NOTE:
? For transmitter codes can be registered at the same
time.
? When fifth transmitter code is registered, the oldest
one will be cleared.
? Register transmitter code(s) to be used in total four
times to delete registered transmitter code(s).

If transmitter/door lock controller is replaced with new one or additional
transmitter(s) is necessary, program transmitter code(s) as
follows.
1) Confirm that all the doors are closed and the ignition key is
out of the ignition cylinder.
2) Open the driver?s door. Insert the key and turn the ignition
switch to ?ON? position within 10 seconds.
3) Turn the ignition switch to ?OFF? position within 10 seconds.
4) Push and release the driver?s door switch (1) 3 times within
20 seconds.
5) Turn the ignition switch to ?ON? position within 10 seconds.
6) Turn the ignition switch to ?OFF? position within 10 seconds.
7) Press and hold both ?LOCK? and ?UNLOCK? buttons (2) on
the transmitter (3) for more than 5 seconds within 20 seconds
(after step 6). All the doors will lock/unlock to confirm
that this process has been properly done.
8) Press ?LOCK? or ?UNLOCK? button (2) on the transmitter (3)
within 5 seconds (after step 7). All the doors will lock/unlock
to confirm that this process has been properly done. With
this process, the transmitter has been programmed.
9) If you want to program the additional transmitter, repeat the
procedure from Step 1) through Step 8).
10) Make sure that the keyless entry system properly operates
by operating each transmitter.

GOOD LUCK!!!