by looking in my crystal ball is on the left ) measure the grounds man!
by looking in my crystal ball is on the left ) measure the grounds man!
how I can test it? I want connecting bmw edc16
I ADD new picture. Is that correct?
Last edited by Harrycz44; 22nd February, 2011 at 09:29 AM.
Pleas where is pin 1 and 10
have you read my post? MEASURE THE GROUNDS!!! then come back here and tell us where you have grounds and I will tell you where is pin 1. please read before posting again and again and again! If I tell you a stupid thing based on my assumptions and you will burn an expensive ECU who is going to pay for it? Me or you?
Maybe will help:
Bals-online.ro • BDM 100 show connection instruction for pads
check the grounds on the ECU also
THANK YOU ALL.... BAZARE ALFY YOU ARE GREAT DK
nice to see it helped, that topic Bals-online.ro • BDM 100 show connection instruction for pads
was made by me after I burned an ECU from a BMW and paid 1000euros for a new one.
beware and have patience reading and measuring the BDM clone before using it, I learned that the hard way.
here's my BDM100:
I only have one GND at the lower middle pin - with a red circle on the picture!
Can anyone tell me which one is pin1?
all bdm 1 pin is top right
A:bad clone
b:good clone reading sid803
c:dimsport org
Bookmarks