audi a6 abs problem

[latino]

hello. i have audi a6 2.5 tdi -150cv 1999

when i move the ecu(abs) pins the abs whork ok but not evry times i already open the ecu but dont see any problem ....the thru is when the abs fails i move the conector of ecu and whork again,can anybody help whith this thanks ..

[grinovsky]

bad contact between connector and abs centrale

[ominimicu]

is that a bosch ABS 5.5 ?

[latino]

hi .is bosch ABS/ASR 5.3 8E0614111AH

[latino]

hi .i post o foto (its the only way i can make abs ecu work) i think "drinovsky" have right there is any solucio for that..thanks

[grinovsky]

open the ecu and resolder all connectors contact

[jjrp255630]

hello. i have audi a6 2.5 tdi -150cv 1999

when i move the ecu(abs) pins the abs whork ok but not evry times i already open the ecu but dont see any problem ....the thru is when the abs fails i move the conector of ecu and whork again,can anybody help whith this thanks ..

hi,, you need to cut the plastic cover, and under the fluid you will find tiny wires conecting to plug.. use a microscope, and you will see 2 wires broken. you just need to re-weld them.

if you dont have experience , or microscope, do nothing.

good luck

[latino]

hi .i have a microscope and sume experience .just on thing do you use any kind off expecial solder or a normal solder thanks

[igendek]

Open and post the picture. i1m going to paint You where should you check connections.

[Ashraf6119]

Hi

There you go.......... if your eyes are good and your hands are not shaking then I am sure you will be able to do the job.........

Good Luck.........


removing "snot-like" goo from ABS circuit board- Bluebee pls. read! - bimmerfest - BMW Forums

[javilette]

you need resolder this

[djemai]

hello
What type of product you can do is hold the welding wire?
thank you

[dolp]

Check the wires I had problems with +12 line

[mlulic]

Essential steady hand