Does anybody know how to put a 70-pin caterpillar ECM in boot rom mode? I don't have any special Caterpillar harnesses or anything. I have a dead ECM that I'm trying to revive.
Any help is greatly appreciated. Thank you!
Results 1 to 4 of 4
-
7th March, 2011, 08:25 PM #1Top Poster
- Join Date
- Jan 2011
- Posts
- 174
- Thanks
- 9
- Thanks
- 10
- Thanked in
- 6 Posts
Caterpillar 70-pin in boot rom mode??
---:..Gratitude is the best attitude..:---
-
9th May, 2011, 05:07 PM #2Top Poster
- Join Date
- Jan 2011
- Posts
- 174
- Thanks
- 9
- Thanks
- 10
- Thanked in
- 6 Posts
*bump* bump bump bump. Anybody have any ideas?
---:..Gratitude is the best attitude..:---
-
22nd July, 2011, 04:07 PM #3Top Poster
- Join Date
- Jan 2011
- Posts
- 174
- Thanks
- 9
- Thanks
- 10
- Thanked in
- 6 Posts
Does anybody know if this is possible or not?
Help!---:..Gratitude is the best attitude..:---
-
25th July, 2011, 12:26 AM #4Top Poster
- Join Date
- Jan 2010
- Posts
- 100
- Thanks
- 34
- Thanks
- 7
- Thanked in
- 5 Posts
Dead ECM
The break out harness u need is a 167-9225 that does a 70 pin and a 40 pin is a 129-2018 I have never done boot rom ,try it through win flash in et if still no good check the pins on the ecm ,I have all so very lighty with fine sand in my beadblaster cleaned the pins but very fine and lightly that seems to work for me
Originally Posted by SaMirakle
Reply With Quote
Bookmarks