hello to all.....i have problem with this ibiza........the car starts for three seconds and then stop.....i switch off the ignition and again on and car starts again for three seconds......i have no comunication to ecu or to immo with my diagostics....vag com,actia......i check all the fuses and all ok....i have +12 to immo permanent and +12after ignition..........i suppose that is immo problem...how can i make it immo off????
ecu6k0906027 0261204844
immo siemens5wk47740 6h0953257b
Results 1 to 8 of 8
Thread: problem with ibiza 99
-
11th April, 2011, 10:30 AM #1DK Veteran
- Join Date
- Jun 2010
- Posts
- 1,394
- Thanks
- 449
- Thanks
- 95
- Thanked in
- 58 Posts
problem with ibiza 99
-
11th April, 2011, 10:38 AM #2DK Veteran
- Join Date
- Nov 2009
- Location
- BULGARIA
- Posts
- 774
- Thanks
- 472
- Thanks
- 471
- Thanked in
- 139 Posts
reed eprom 27c512 and post dump
-
11th April, 2011, 10:52 AM #3DK Veteran
- Join Date
- Jun 2010
- Posts
- 1,394
- Thanks
- 449
- Thanks
- 95
- Thanked in
- 58 Posts
from ecu??????????
-
11th April, 2011, 12:51 PM #4V.I.P. Member
- Join Date
- Mar 2009
- Location
- On a rock
- Posts
- 4,336
- Thanks
- 43
- Thanks
- 68
- Thanked in
- 64 Posts
Does it have immo 1 with separate immo box under dash, follow the transponder antenna and see where it goes, if it has have a look at wiring diagram then bridge DLC & K line and see if you can get coms with ECU or just double check all earths to make sure they are good or run wire direct from DLC to ECU
Originally Posted by d.zio
Last edited by Liteace; 11th April, 2011 at 12:56 PM.
-
11th April, 2011, 01:51 PM #5DK Veteran
- Join Date
- Jun 2010
- Posts
- 1,394
- Thanks
- 449
- Thanks
- 95
- Thanked in
- 58 Posts
yes it has seperate immo box.......which wires have i to bridge??
-
11th April, 2011, 02:19 PM #6V.I.P. Member
- Join Date
- Mar 2009
- Location
- On a rock
- Posts
- 4,336
- Thanks
- 43
- Thanks
- 68
- Thanked in
- 64 Posts
DLC goes to immo then ECU, on 6 pin plug of immo box I think there +12v, 2 x earths, DLC in (k-line) immo to ECU, and 1 pin that is not used, use tester to see what is DLC > immo > ECU then bridge them 2 on immo box, I don't have any wiring diagram to look at, at mo. Does it have airbag and can you coms with it ?
Sent from my iPhone using Tapatalk
-
11th April, 2011, 07:11 PM #7DK Veteran
- Join Date
- Jun 2010
- Posts
- 1,394
- Thanks
- 449
- Thanks
- 95
- Thanked in
- 58 Posts
THanks mates.....solved....
was the ecu.....i reclased with a second hand,made the adaptation and all ok......
THANKSSSS
-
11th April, 2011, 09:05 PM #8V.I.P. Member
- Join Date
- Mar 2009
- Location
- On a rock
- Posts
- 4,336
- Thanks
- 43
- Thanks
- 68
- Thanked in
- 64 Posts
Nice to see you got it sorted Originally Posted by d.zio
Reply With Quote
Bookmarks