MMPS problem VW 2.0tdi EDC16U1 flashing

**budG60** · 30th April, 2011, 12:52 PM

Hi,
I have read and programmed many edc16 with my mpps tool, but today I faced a problem with an edc16u1 ecu in a golf 5 tdi, which seemed to go fine, but after writing 100% it shows "incorrect conditions" and the car does not start anymore (does not seem to be a checksum error!) and the fans start running. I have tried to program the ori file back, but no change.
I can still daignose it with vcds, but it gives an unsupported error even though I can still read th hardware number etc.
Any suggestions?
Does anyone have a bdm of this ecu?
03G906016ET 0281011843 375890.
Any suggestions are welcome?

**Joe019** · 30th April, 2011, 01:05 PM

Make BMD recovery

**cfgebel** · 30th April, 2011, 11:39 PM

here .... ...

**jolidj** · 1st May, 2011, 12:28 AM

you try the recovery write??
retry a recovery write and correct the chk.
i dont have nevere problem whith this ecu.
if you have bdm you save.

**mishu_b** · 1st May, 2011, 11:53 AM

...
I had the same bad experience with this car - I solved the issue by using galletto.

atb

**rappttor** · 1st May, 2011, 11:58 AM

try to flash it on the table if it doesnt work on the car, anyway bdm should do the work

**frangct** · 1st May, 2011, 11:59 PM

Thaks for ori

**levisdj** · 2nd May, 2011, 08:56 AM

You got the first error because the file you wrote, didn't have corrected check sum.Quote mishu_b re flashing the ORI file with Galetto should do the trick, if you have this tool available.Good luck

**ecutuners** · 2nd May, 2011, 09:12 AM

Originally Posted by levisdj

You got the first error because the file you wrote, didn't have corrected check sum.Quote mishu_b re flashing the ORI file with Galetto should do the trick, if you have this tool available.Good luck

Mpps should calc chks on that ecu I have done many many

**mircea13** · 30th November, 2015, 06:55 PM

i have and edc16u1 from an A3 8p to tune this week. mpps v13 or galleto fgtech v54? this is the question ? have also ktag 5.0 china. but i don't want to take ecu off from the car. i plan tho remove the fan fuse, because they start on a lot of cars when eeprom is erased, and they will drain the battery durin writing. another question

n galletto fgtech v54 tool 0386 should i use k line or can for edc16u1?