Make BMD recovery
Hi,
I have read and programmed many edc16 with my mpps tool, but today I faced a problem with an edc16u1 ecu in a golf 5 tdi, which seemed to go fine, but after writing 100% it shows "incorrect conditions" and the car does not start anymore (does not seem to be a checksum error!) and the fans start running. I have tried to program the ori file back, but no change.
I can still daignose it with vcds, but it gives an unsupported error even though I can still read th hardware number etc.
Any suggestions?
Does anyone have a bdm of this ecu?
03G906016ET 0281011843 375890.
Any suggestions are welcome?
Make BMD recovery
here .... ...
t1tan1 (1st December, 2015)
you try the recovery write??
retry a recovery write and correct the chk.
i dont have nevere problem whith this ecu.
if you have bdm you save.
...
I had the same bad experience with this car - I solved the issue by using galletto.
atb
try to flash it on the table if it doesnt work on the car, anyway bdm should do the work
Thaks for ori
You got the first error because the file you wrote, didn't have corrected check sum.Quote mishu_b re flashing the ORI file with Galetto should do the trick, if you have this tool available.Good luck
Kess v2 FW 5.017 full unlimited token - Ktag 7.020 full unlimited token
ALL EDC17/MED17 EEPROM CHECKSUM + VAG IMMO OFF BY EEPROM - NO SAFE
EDC16/17 POPCORN - ME7/7.5 ANTI LAG - LAUNCH ALS/NLS
DPF EGR DTC SCR, Custom Tuning, Damos Translation, FRF / SGO Files
Professional Engine Software Development
i have and edc16u1 from an A3 8p to tune this week. mpps v13 or galleto fgtech v54? this is the question ? have also ktag 5.0 china. but i don't want to take ecu off from the car. i plan tho remove the fan fuse, because they start on a lot of cars when eeprom is erased, and they will drain the battery durin writing. another questionn galletto fgtech v54 tool 0386 should i use k line or can for edc16u1?
mpps 100%100....edc16u1
Chk ok... is calculated by mpps..
Trimis de pe al meu SM-G900F folosind Tapatalk
Bookmarks