Help with das install

**Zake** · 8th May, 2011, 12:19 PM

Hi m8s!
Please help me..
After I install Das with no erors...the program don't see the multiplexer...
I have the tipe of multiplexer with usb conector...

Best regards.

**mercis** · 8th May, 2011, 03:02 PM

work only with com port2
wich multiplexer have usb connector??

**Zake** · 8th May, 2011, 07:04 PM

I switch the port to com 2...
"wich multiplexer have usb connector??" I don't understand this question.

**mercis** · 9th May, 2011, 05:33 AM

original and china clona multiplexer work with com port,
you have with usb?

**DB_member** · 9th May, 2011, 07:18 AM

Originally Posted by Zake

I switch the port to com 2...
"wich multiplexer have usb connector??" I don't understand this question.

I have never seen a clone that would not have a serial port interface. Can you post a photo from your setup? You probably are using a USB to RS232 serial port adapter which isn't good (in most cases). If your laptop does not have a serial port, you should use a PCMCIA adapter.

**Zake** · 9th May, 2011, 11:30 AM

Mates...I will post tonight some photos...I have the multiplexer for about six-seven years.

**mercis** · 9th May, 2011, 11:42 AM

MBStarDiagCarHelp (com+usb))
good tool

**Zake** · 9th May, 2011, 03:31 PM

Originally Posted by mercis

MBStarDiagCarHelp (com+usb))
good tool

I think it is not like that...
Here are some photos:

BTW: I solved my problem...my mistake...I jump over step 10 from the guide...

Thanks to all.
Best regards.

**DB_member** · 9th May, 2011, 03:35 PM

Originally Posted by mercis

MBStarDiagCarHelp (com+usb))
good tool

The photos at the link are only visible for registered forum members (of that forum) but I think I know which tool you are referring to. I thought that was rare outside Russia?

**Zake** · 9th May, 2011, 05:01 PM

Can you explain me please what xentry and tan are?
What are the diferecnes betwen Das and Xentry?
And what else aditionall programs for Das exists?

Thanks.