have you got the dish installed and lined up if not you will need a compass a sat meter just the cheap swinging needle type a adjustable spanner, set the dish facing south check the book that came with the motor and you will find a table in there that gives you the angles to set your dish up with compared to your long and lat connect your coax cable with the f connectors 1 from your 500s to the your meter and the next from the meter to the lnb powering up your dm(dreambox) go back up the ladder move the dish very slightly towards the west till your signal on the meter gives a good signal now tighten up all the bolts(you may have to tilt it from top to bottom slightly)take the meter out of line and connect the motor up.Now go back to your box going through the set up PAL,time ect i would un tick the goto option but that a personal choice(your dish should be pointing at 1west thor).this is were you must select save sat adjusting slightly to get the best signal via the remote saving the sat when a good signal is found then save all the sats you want save 13e,16e,19,28e,30w ok if its flashed then that means the image that you are using ie darkstar what you need to do is first connect up your ethernet cable from your rooter to your 500s in the setting menu you will need to configure your ip eaddress of your box untick dhcp and put in a ip address to suit ysour rooter ie 192.168.1.4. then on your remote if you are using nabilo image prees the yellow button twice and download Cccam lastest version(2.011 i think)then you should start scanning you sats for channels
Bookmarks