Porshe Durametric Software needed for China Clone

[PhrogPhlyer]

@eastern, do you still have Durametric version 5.0.8.0? If so, can you please send to me or upload on web where I can download? Thank you.

Turbo - Did you get Ver 5 from Eastern? If so can I get a copy?
Thanks

[peterjohn]

Hi Everyone,
does someone have the 5.0.x version? If so may I have a copy?
Thanks in advance!
Peter

[lemm]

Hi Everyone,

I am having the same issue.

Does anyone have the 5.0.x version? And may I have a copy, please?
Thanks in advance!

lemm

[bmartin]

Hi Everyone,

I am having the same issue too.

Does anyone have the 5.0.x version? And may I have a copy, please?
Thanks in advance!

bmatin

[dingers]

Hi,

Hopefully this thread is still alive. The present available version following advice in reply 2 gives 5.14. I am tempted to try this but worried about damaging the management unit "Bricking it". However if V. 5.0 is available does anyone have ideas as to where from? Any assistance or advice would be appreciated. Thank you.

[Superblond]

This is the 3.x version of that P_RSCHE PIWIS / DURAMTIC Kabel Software.
https://mega.nz/#!BcpBRYYT!3ePndTV5q...N1e2AI2Pu51uBM

That version woked with my chhina cable version....

Also included drivers and NetDot if needed.
To start that tool you need to have the cable pluged into the usb port and the car ODB port.

If you run into any problems, choose WIn7 compatibility mode, or WinXP SP3.

Plz share an spread.

If the link is down, just PM me...

SB

[maxtor911]

hello guys,
still wondering if v5.0 works on the china clone?
can anybody write a reputation if clone and version 5.x.x is tested successfully?

regards