My OpenBox S10 doesn't turn off by remote control!

[lamp]

I have the last firmware in the receiver.

When I try to shut down by remote control,
the display goes off, no function works, but
continues to run the tuned channel and have
voltage feeding the dongle (rear output v 12).
Some information about this bug?
Thanks a lot!

[the man]

read a few guys having the same thing

[lamp]

read a few guys having the same thing

OK, my friend.
I will continue the search for solution.
Thanks - and success!

[lee1975]

press menu > infomation >ok , press button "Red, Green, Yellow, Blue, 8"
Then press the Power button on the remote control

worked for me might have to try a few times

[lamp]

press menu > infomation >ok , press button "Red, Green, Yellow, Blue, 8"
Then press the Power button on the remote control

Thanks for the interest in help me.
I will try - and return with results.
Mr. Lee is a good companion!

[lamp]

press menu > infomation >ok , press button "Red, Green, Yellow, Blue, 8"
Then press the Power button on the remote control

Hello, Mr. Lee.

This explanation not work.
I insert new firmware, of the Skybox, (attached)
and now is OK. But the 12 volts - rear connector -
only turn off by power switch.

[althom40]

press menu > infomation >ok , press button "Red, Green, Yellow, Blue, 8"
Then press the Power button on the remote control

worked for me might have to try a few times

Well done Mr Lee. I have been searching for months to find a solution to this remote problem. I have an S10 but loaded
the latest 7/12/2011 FW into the box and that is ok but still no
standby from remote control until I followed your tip. Amazed it works.
Please tell me how you got your info about this?

regards

[slugworth]

That trick doesn't work for older firmware,I tried it with 5-5-2011
Later firmware during the summer had the problem fixed.

[althom40]

well slugworth, I had standby working with the April 11
firmware, but right through until Oct 11 I could not get it back.
I just switched off at the rear.

But this latest FW which was for the skybox works in conjunction with Mr lees tip.

This new FW is the only updated version which I have downloaded that does not have some problem with it.

Now I am looking for a fix to enable me to put in keys for
Seca/Mediaguard/Nag2. At the moment I can only load Crypto and Idto. I need the rest to view RAI encrypted channels which I can with my Technomate box.

[slugworth]

I never had a problem with standby after the 5-24 firmware release.
Forget about nag2 and openbox.

[micky10]

i tried as you discribed and it worked

thank you

[budgie78]

so is this ok to use in uk

[DW190]

so is this ok to use in uk

Yep works a treat.

[razorkaos]

The trick
press menu > infomation >ok , press button "Red, Green, Yellow, Blue, 8"

worked for me too but i can't go back,
any idea to get back no standby?