xprog-m and bdm adapter problem

[emiliogsm]

hello , i have problem with reading all kind of secured MCU when use a BDM adapter .I am never have a problem bifore but today i am try to read motorora 9s12DG256 and programmer stay at bypas security .....and nothing ....
i am try with other secured MCU some problem .
When i try to read other motorola MCU on other adapter all work OK .
hope someone have idea for this isues

thanks in advance

[pnj]

Make sure wires is not to long and the right pair is twisted.

But is worked before this should not be problem unless you changed anything or is right on the limit.

If still nor work BDM or progermmer is proberlly bad :-(


Good Luck

[emiliogsm]

Make sure wires is not to long and the right pair is twisted.

But is worked before this should not be problem unless you changed anything or is right on the limit.

If still nor work BDM or progermmer is proberlly bad :-(


Good Luck

i am get a perfect 5V vcc , also have a 4.7-5V on reset , 3.6 on BKGD .....
strange problem

[Music73]

Just Trying to read a focus 2008 dashboard with a mc9s12xhz512val with mask 1m80f using a xprog-m 5.0 clone.. but gettting error "Part ID 0xE400"

Tried reading as 9s12xdp and also 9s12-eeprom..

can anyone give me some advice on this..

P.S. do i also have to power the dash..??

[tehnosoftex]

Just Trying to read a focus 2008 dashboard with a mc9s12xhz512val with mask 1m80f using a xprog-m 5.0 clone.. but gettting error "Part ID 0xE400"

Tried reading as 9s12xdp and also 9s12-eeprom..

can anyone give me some advice on this..

P.S. do i also have to power the dash..??

I think that this MCU is not supported by xprogM v 5.0