Hello all,

Got a factory GT1 that I've replaced a dead hard drive on. Formatted to fat32 with a 18.63 gig partition. The drive is 40gig. When I set partition size to 18.63 the install 1.1 cd does not like that the end does not represent the end of the drive and asks to use force...Does not give a method though.
When the partition size is left at 40gig it is fine. But either way I get a partition error when installing base v39. I've tried changing hdd parameters to 2434 255 63 but no hope. Any insight would be very useful...I've been stuck for a couple days. Also when the GT1 is in the cradle v39 says no hard disk controller. I found if installing it recognizes the hdd and lets me dparam -w the hdd.
Help