Cummins INLINE 5 INSITE 7.5 setup

[autodiagnostic]

Cummins INLINE 5 is not easy to use especially for the beginers, I find one

[dimitar22]

volvo truck 8 pin.jpgI have one question i need pinout from the inline 5 interface so i can use it with vcads pro.

I found this pinout on the forum, but in order to make one a need to know what the eight pins on the volvo connector are which is GND which is VIN and so on, and which pins correspond on the inline 5 adapter.

[dimitar22]

I found that

Pin 23 is 24V-
25 is 24V+
6 is J1939+
8 is J1939-
4 is J1708/1587 LO
3 is J1708/J1758 HI
This is on the inline 5 interface.
But now i don't know if J1708 LO is J1708 plus or minus ?

And can some one please confirm that the pinout on the picture above for the volvo 8 pin is correct?

[pbateman]

Hey fellow DK friends don't know if anyone has seen them or not yet but Cummins has released a new inline 6 thought the information would be helpful to those who are using inline adapters.

http://inline.cummins.com/downloads/I6DriverSetup32.zip
http://inline.cummins.com/downloads/I6DriverSetup64.zip
http://inline.cummins.com/onlinemanu...tructions6.pdf

[mozzie]

Hey fellow DK friends don't know if anyone has seen them or not yet but Cummins has released a new inline 6

Yes i suppose they had to do something
the inline 5 was a dud.

Check out the Dec2011 newsletter;
-says inline 6 has support for J2534 also.

https://insite.cummins.com/insite/info/index.html

[renesis]

why is the Inline 5 a dud?
I have been using it for the past 4 years and all is well... except I cannot get Wabco Toolbox/Volvo Vcads to work through it.

[mozzie]

why is the Inline 5 a dud?
I have been using it for the past 4 years and all is well... except I cannot get Wabco Toolbox/Volvo Vcads to work through it.

Many of them just stopped working;
was unpredictable when sometimes
less than a year sometimes after yrs.

[kitty-hawk]

Dimitar,

Pinout volvo connector for DPA4+ or nexiq USB.

[renesis]

Many of them just stopped working;
was unpredictable when sometimes
less than a year sometimes after yrs.

thanks for your warning.. means I should be getting a replacement set for standby...
will inline6 work with older insite 7.4?

[jctech]

thanks for your warning.. means I should be getting a replacement set for standby...
will inline6 work with older insite 7.4?

Inline 6 works with Insite 7.5 and later, Inline 6 is supposed to support all Cummins Electronic engines.

service tool instruction attached

[Roy Suryadwiananda]

Inline 6 works with Insite 7.5 and later, Inline 6 is supposed to support all Cummins Electronic engines.

service tool instruction attached

Friends, if you have a Cummins Cummins adapter firmware 5.6.4.3 for Inline 5, beg to be shared here, thank you.

[yogosutirto]

Friends, if you have a Cummins Cummins adapter firmware 5.6.4.3 for Inline 5, beg to be shared here, thank you.

Take here . . .

http://www.digital-kaos.co.uk/forums...b-inline-5.rar