Hi what cable are you using Null or USB
If USB are you using the correct com-port ??
also which software program there are a few
Hi, got a dead F5S, and having read thru the whole of this thread, which is brilliant, im still stuck, "STB Memory error"
(IF it comes with set STB memory error please run config.bat file (Located in folder you have downloaded and unzipped) ) before running loader
Can anyone explain how to run the config.bat file successfully , then maybe i will get passed this point
Cheers in advance
mike
Null via usb adapter on my laptop or Null direct via serial port on my PC, same result on both
used several eprom update versions 2.0.0c and 2.0.1 and every version of .ABS i can find for original F5S and Clone F5S
but i still end up here, with the stb, also been into device manager and slowed the buffer rate right down,
and it still wont go
so the qusetion was how do u run the config.bat file
mike
so the question was how do u run the config.bat file........ never had to
Use one of these loaders.....
erom_upgrade_8Mflash.rar
Upgrade_PVR800_HD_Tool.rar
Firmware below..........update20150713.zip
Check your computer is using the correct com port.....see 1st photo com port
this must match this com port see 2nd photo ....eprom update com port
Tick boot loader & try again
You now have all you need to get the box back up & running
If everything works & then you get file mismatch you have a clone box
which is a different firmware
CrAcKeDuPII (18th August, 2015)
Hi P&D,
Thanks for all your help on trying to bring the boxes back to "life."
I've got an old F3 that is constantly rebooting after a recent favourites update by USB. This isn't the first time I've seen this happen either. It eventually just stays on L100. Anyway I have used the null modem cable and have managed to complete the process of reloading the software several times, but the same fault persists. Just wanted your opinion......time to give it up as a bad job? BTW I have just about every loader and all versions of the software, but none seem to cure the problem.
Cheers,
CrAcKeDuPII
Last edited by CrAcKeDuPII; 18th August, 2015 at 11:47 AM.
Hi with the F3 are you using the correct firmware ??
are you also ticking boot load on the screen where you load the firmware ??
The last firmware for the F3 is below.......this is the one i always use
where abouts are you if close i can do the box for you 10 mins top's
or see DW190 post here ......http://www.digital-kaos.co.uk/forums...=1#post2189552
Just wondering if someone could help me , I have a v5s open box and my father is looking for a box like this but I see that a newer version the v8s is out now ,would I be best off going for that box is there much of a difference and I guess it's the same set up , any help would be greatly appreciated
I've got the v8s and mine is stuck on strt booting screen where it says openbox, so I'm assuming I need to buy a cable ?
Thanks in advance only had the box a yr and already had to sort anew server out after being scammed
Anyone help me out please i had my friend bring her v8s box which was stuck with load on the front, so i flashed it. And now it dont do nothing no lights comming on nothing? Any ideas? thanks josh
It seems to have moved since I last linked to it.
Here is the new link.
Read from post#65 for the solution.
http://www.digital-kaos.co.uk/forums...ht=coincidence
Last edited by Hadron; 18th November, 2015 at 06:00 PM.
thank you for this much appreciated
Hi, can you install channel lists through this cable?
Bookmarks