I plug the power supply 12 volt,and reset cable.and can low.plus bridge pin 1 and 2.lift pin 2.with negative results.with my digiprog3.shows error.try few times a ready.
I plug the power supply 12 volt,and reset cable.and can low.plus bridge pin 1 and 2.lift pin 2.with negative results.with my digiprog3.shows error.try few times a ready.
maybe this one can help you!
Last edited by mecjp; 27th March, 2018 at 12:31 PM.
sharing is the key of success
The 2001 ford mustang with digiprog3 works great. The above picture post are wrong. Blue Cable reset.is wrong.to make it work.you need.to lift pin 2 only.and join together with pin 1.put 12 volts red wire on pin 11 and 12. And ground negative on pin 13.on the big socket input harness.put the yellow low can where the picture above show.and put orange or green cable high can.where the blue cable show.and ready to go.works great. Some cables #35 some times can high come on green color and some times orage.good luck.
smelecom cmm adapter no open solder lift pins
Reading is fundamental, asking is easy............................
Hello Im having same issue Im using carprog and need to know which cables to connect please thank you.
Attachment 618930Please point out the connections thank you
Bookmarks